The purpose of the stranding machine
Widely used for stranding various soft/hard conductor wires (copper wire, enameled wire, tinned wire, copper clad steel, copper clad aluminum, etc.) and electronic wires, such as power lines, telephone lines, audio lines, video lines, automotive lines, network lines, etc. Twist multiple single conductors into one strand to meet the requirements of wire technology.
Precautions for stranding machine
1. During normal operation of the machine, it is strictly prohibited to open the machine cover.
2. Do not make dead knots during wiring. (Use cotton thread for splicing, pay attention to the direction of splicing)
3. When removing the shaft, the number of knots and the number of knots in meters should be indicated on the label for the convenience of the next process operation.
4. Do not press the red emergency stop button unless it is an emergency stop.
5. Turn off the power after shutdown.
6. When wrapping aluminum foil, the core wire should be completely covered by the aluminum foil. Usually, the overlap rate of the aluminum foil is 27% -30%, and the overlap width is 2-4mm (refer to the specific requirements of the wire card for special models).
7. The tension of aluminum foil should be appropriate. If the tension is too high, aluminum foil is prone to cracking, and if the tension is too small, the package may not tighten the core wire and slip.
8. Aluminum foil cannot be wrapped upside down, and the conductive surface (white bright surface, tested with a multimeter to be conductive) must cover the core wire and ground wire.
9. The ground wire cannot be wrapped in the middle of the core wire, but should be wound on the side of the entire core wire to make contact with the conductive surface of the aluminum foil.
10. If any abnormalities are found during production and cannot be resolved by oneself, immediately shut down the machine and report to the foreman or technician for handling.
11. When installing the wire passing eye mold, pay attention to the size and do not tighten the twisted core wire too tightly when passing through. To prevent scratching the core wire.
12. The tension adjustment should be appropriate (when too tight), which can cause the internal core wire to become taut when the outer cover is intact.